Eductor air.
Cooling of exhaust gases from 900 — 1000 0 C to around 350 0 C.
IV. Eductor Assembly for :
indicators and
3. Type of fuel : LDO / HSD
Waste, moisture content, calorific value, etc. and shall vary from waste to
Without stack
Burners temperature controlled (TIC — Thermocouple) and operate on ON —
5. Expected gas consumption: 30-35 kgs/hr **(depending upon overall
approx. expected fuel consumption figures.
The Incineration System comprises of :
I. Main Incinerator with
B. Bucket elevator + DFDV mechanism for autoloading and Deashing
waste. The gas consumption also depends upon the frequency of the doorway
As per our requirements we would like the YD 15C little incinerator.Mixed Biomedical waste Incinerator.Contract period:To be determined by the supplier
ii. 1 No. Fully automatic Fuel Oil burner for secondary space.
Dampers, etc. mounted on the common skid of the unit to provide:
Payment provisions:100% prepayment through bank TT after signing of contract.
Please confirm your willingness to do this contract project by sending brochure along with your price quotation for the below specification to enable us submit it to the firm incharge of the contract for their analysis and approval.
mechanism
VII. Oil tank of 1000 ltrs capacity mounted on the slide
THE BURNER SHALL USE DIESEL/OIL
VIII. Running tools and tackles comprising of — rake, hoe, shovel (I No. each).
II i. 1 No. Fully automatic Fuel Oil burner for primary chamber.
III. Centrifugal forced draft fan assembly complete with motor drive, duct and
V. Electrical Control Panel along with safeties, and Audio / Visual
VI. Electrical wiring of the device.
7. Total space requirement: 9 m (L) X 8 m (W) X 6 m (H) Each unit
Keeping the Whole system under negative pressure to prevent hot gases / dust
4.
IX. Chimney of 2.5 Mtr height.
The Incineration System comprises of :
I. Main Incinerator with
A. Primary & Secondary Chamber Modules duly refractory lined, piped & wired.
B. Bucket elevator + DFDV mechanism for autoloading and Deashing
mechanism
II i. 1 No. fully automatic Fuel Oil burner for primary chamber.
ii. 1 No. fully automatic Fuel Oil burner for secondary chamber.
III. Centrifugal forced draft fan assembly complete with motor drive, duct and
dampers, etc. mounted on the common skid of the unit to provide :
Combustion air.
Eductor air.
IV. Eductor Assembly for :
Cooling of exhaust gases from 900 – 1000 0 C to around 350 0 C .
Keeping the entire system under negative pressure to avoid hot gases / dust
particles rushing out of charging door.
V. Electrical Control Panel along with safeties, and Audio / Visual
indicators and
/ or alarms for efficient and safe operation of the system.
VI. Electrical wiring of the unit.
VII. Oil tank of 1000 ltrs capacity mounted on the skid
VIII. Operating tools and tackles comprising of – rake, hoe, shovel (I No. each).
IX. Chimney of 2.5 Mtr height.